Originally posted by DT8666
View Post
Announcement
Collapse
No announcement yet.
Quad Copter - The Journey started
Collapse
This topic is closed.
X
X
-
Anyone here have used a freq tx to arm a quad x? I hv problem arming mine. I m using a futaba t6xhs.
The usual way dun arm it. I resetted the tx but still can't. Can anyone help? Thx.Mugen Mrx2, HW 4274, HW Xerun150esc 6s
SCRT, HW Sct motor, HW Xerun120esc 2s
Team Driver for HobbyWing, Acorn racing & ManiacRC
Comment
-
Originally posted by superek4 View PostAnyone here have used a freq tx to arm a quad x? I hv problem arming mine. I m using a futaba t6xhs.
The usual way dun arm it. I resetted the tx but still can't. Can anyone help? Thx.
and if that still not able to arm the motor, please down trim your throttle and try again.
To ARM, please ensure the throttle is at lowest, apply rudder right to arm. the LED light on the controller should lights up.
If you still have issue, lets meet up again.
Cheers!
Comment
-
Originally posted by DT8666 View PostSetup should still be the same. please remember that you have to Reverse the Channel 3 (throttle).
and if that still not able to arm the motor, please down trim your throttle and try again.
To ARM, please ensure the throttle is at lowest, apply rudder right to arm. the LED light on the controller should lights up.
If you still have issue, lets meet up again.
Cheers!Mugen Mrx2, HW 4274, HW Xerun150esc 6s
SCRT, HW Sct motor, HW Xerun120esc 2s
Team Driver for HobbyWing, Acorn racing & ManiacRC
Comment
-
Originally posted by roypwee View PostDT8666,
Any improvements on the Quad X?
Have not been flying for a while as my Tx is in for service.
have you seen my Octo and Hexa flying yet???
Octo was with maiden flight at the scale event and the second Octo on Tuas scale event.
Comment
Comment