If this is your first visit, be sure to
check out the Rules and Help. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Ya.. somehow gotta squeeze abit even after tearing off the green shrinkwrap.
Impt thing to note is redirect the batt wires to come out from the top of e batt rather den the side. This is to protect the wires from chafing while plugging the batt in & out.
Also be sure of the polarity of the connector before plugging in. For mine, the +positive (red) pin is on the right when looking at the tx connector.
Disclamer: Powering up my a fully charged (12.6V) 3s lipo with e above instruction works for my jr-9x. Dun hold me responsible if this method fries ur tx..
Fixed-Wing
GWS Zero
Fliton Extra 260
Hacker SuperZoom 4D
Thunder Tiger Velocity
Scratchbuilt Depron Profile Extra 300
Thunder Tiger SuperCub (RIP - Resting In Pieces)
Scratchbuilt Lama Plane
RICCS Mirage 2000 #1 (RIP)
RICCS Mirage 2000 #2
Rotorcraft
Thunder Tiger Mini-T
Esky HBK2
Esky Lama V4 w/SuperShaft
Ya.. somehow gotta squeeze abit even after tearing off the green shrinkwrap.
Impt thing to note is redirect the batt wires to come out from the top of e batt rather den the side. This is to protect the wires from chafing while plugging the batt in & out.
Also be sure of the polarity of the connector before plugging in. For mine, the +positive (red) pin is on the right when looking at the tx connector.
Disclamer: Powering up my a fully charged (12.6V) 3s lipo with e above instruction works for my jr-9x. Dun hold me responsible if this method fries ur tx..
thanks bro , u mean no need to mod the batt? and using the balance connector? i have a king2 1000mah too, intend to use for my optic 6.
thanks bro , u mean no need to mod the batt? and using the balance connector? i have a king2 1000mah too, intend to use for my optic 6.
For me, I tear out e green wrap, bend the wires over to e top & taped it. Take note tat it's pretty tight, gotta slowly insert.
Din have a good shot on e other side. But guess it should be clear enuf..
Fixed-Wing
GWS Zero
Fliton Extra 260
Hacker SuperZoom 4D
Thunder Tiger Velocity
Scratchbuilt Depron Profile Extra 300
Thunder Tiger SuperCub (RIP - Resting In Pieces)
Scratchbuilt Lama Plane
RICCS Mirage 2000 #1 (RIP)
RICCS Mirage 2000 #2
Rotorcraft
Thunder Tiger Mini-T
Esky HBK2
Esky Lama V4 w/SuperShaft
For me, I tear out e green wrap, bend the wires over to e top & taped it. Take note tat it's pretty tight, gotta slowly insert.
Din have a good shot on e other side. But guess it should be clear enuf..
The Battery ( Esky 1000mah ) is too fat to fix into my 9C
Never regret doing this. I'd been using e fully charged 1000mAh batt for a few flight days (approx. 4-6hrs transmission with 2hrs simulator). Still indicating full bar (11.6V) on my tx.
Fixed-Wing
GWS Zero
Fliton Extra 260
Hacker SuperZoom 4D
Thunder Tiger Velocity
Scratchbuilt Depron Profile Extra 300
Thunder Tiger SuperCub (RIP - Resting In Pieces)
Scratchbuilt Lama Plane
RICCS Mirage 2000 #1 (RIP)
RICCS Mirage 2000 #2
Rotorcraft
Thunder Tiger Mini-T
Esky HBK2
Esky Lama V4 w/SuperShaft
Comment