Charging 2pc of 3s with T15??

[johndyl]

What if you use two balancers (T6B ) one for each li-po and charge in parallel . Get y-cable, plug banana plug of the T6B to charger and li-po connect to the balance tab ?

On the manual for T6B, it says - " When the battery pack is fully charged, the balancer will automatically switch to the Disconnection Mode".

wa u have 2 tb6.. might as well get 1 more charger liao.. prolux one cheap and gd..

btw i have 3 bal charger sets.. probably cost the same as 1 t15 and bal niah

[johndyl]

btw.. though manual says that, it may also fail and when that happens, pls make sure u already have comprehensive fire insurance!

[kkz]

As per manual - its ok to charge two packs of li-po via two balancers. So anyone with two balancers try this configuration out ?

If the balancer can disconnect itself after a full charge then this is one method worth considering !

[nexus05]

Question guys....So i can do series charge of 2 x 3s if my charger can charge 1-10cells? Something like the Hyperione EOi12? Just needs 2 balancer right?

Tks

If you are refering to the Hyperion 1210i charger (can handle up to 12s).. Yes you can charge both 3s at same time using 2 LBA10 balancer with a network cable or something if i remember correctly, you can refer to the manual on the connection/settings.
But i think it maybe highly possible you can charge 2x3s with a single LBA10 balancer as the LBA10 can handle up to 6s. Then again..I am not very sure but you might want to verify again with other users.

[pilot_bear]

If you are refering to the Hyperion 1210i charger (can handle up to 12s).. Yes you can charge both 3s at same time using 2 LBA10 balancer with a network cable or something if i remember correctly, you can refer to the manual on the connection/settings.
But i think it maybe highly possible you can charge 2x3s with a single LBA10 balancer as the LBA10 can handle up to 6s. Then again..I am not very sure but you might want to verify again with other users.

LBA10 can handle 6s as a pack, if you want to charge 2 x 3s, you will need to custom a balancer tab to connect both the pack as one, and also another cable to link up the main connector of the 2 pack in series (11.1+11.1=22.2)
the charger need to support at least 6s charging.
one thing to note, when using network balancer to charge, you are charging in series, not parallel.

option 2.
buy 2 balancer that can do network charging.
the charger need to support at least 6s charging.
can consider.

option 3.
buy 2 charger and 2 balancer
can seriously consider.