Transmitter????????

[Super-Hornet]

I just tried it out in my Hitec Aurora 9.
I set the model type to heli with mCCPM mode.

Then I assign:
Channel #1 to Aileron
Channel #2 to Elevator
Channel #3 to Throttle
Channel #4 to Rudder.
Channel #5 to Auxiliary #1
Channel #6 to Auxiliary #2

Because u did not mention whether do u need Rudder and Elevator or not..so I assign accordingly. If u do not required Elevator and Rudder, then u can assign Channel #2 to Aux #1 and Channel #4 to Aux #2.

Then I use programming mix to create:
ProMix #1: Throttle -> Aux #1
ProMix #2: Throttle -> Aux #2
ProMix #3: Aileron -> Aux #1
ProMix #4: Aileron -> Aux #2

In ProMix #1:
The curve is linear line of 100% to 100%
In ProMix #2:
The curve is linear line of 100% to 100%
In ProMix #3:
The curve is linear line of 10% to 10%
In ProMix #4:
The curve is linear line of 10% to 10%

Then u can connect Channel #3 to motor #3, Channel #5 to motor #1 and Channel #6 to motor #2.

That should give u something u want.

SH

[JDaddy]

Thanks

SH
Thanks-a-lots for your time and effort to provide this clear explanation. Greatly appreciate your help.

[SKYHIGH]

LOL ...I believe Ehawk was asking if YOU are planning upgrade to 14MZ !

....11X ???

Bro,

upgrading tx is a waste of $$. So, dont waste yr $$, buy the transformer ......11x