Info on KDS SV

[SKYHOBBIES]

Hi Bros, i am a beginner and i just bought a 450SV recently.

During the purchase, it was tested and working fine.. however when i when home and pluck in the battery (after charging) to try.. nothing works and just beeping sound and light flashing..

Thot was RTF..

Do i need to bind the receiver and transmitter as stated on the menu ?

How to bind it if require ? cant figure out from the menu ?

Any advice.. Thanks..

Hi mit_evo,

To rebind the receiver, plug-in the BIND PLUG (with an orange tag) that is given in the box. Insert the BIND PLUG into Channel 8 of your receiver and power-up your helicopter.

From your transmitter at OFF position:

1) Press and HOLD Menu;
2) On your Transmitter while HOLDING the Menu Button;
3) Press "Menu" Button 5 times, you will see "Id GEN";
4) Press "UP" Button to select "YES"
5) Press "ESC" to enter.
6) Remove the Bind Plug and disconnect the Lipo Pack on your helicopter.
7) OFF the Transmitter and ON again;
8) Re-connect your helicopter as usual and it will be back to bind.

Cheers!

[RC_999]

Hi Bros, i am a beginner and i just bought a 450SV recently.

During the purchase, it was tested and working fine.. however when i when home and pluck in the battery (after charging) to try.. nothing works and just beeping sound and light flashing..

Thot was RTF..

Do i need to bind the receiver and transmitter as stated on the menu ?

How to bind it if require ? cant figure out from the menu ?

Any advice.. Thanks..

Bro.. just to gentle reminder for safety .. kindly unplug one of the wire from ESC to Motor or Kindly remove the blades form rotor head.. during binding process or if you are making changes for the setting with TX. PLs DO not ask why! .. happen to me with my Belt CP V2. luckily that time I took out blades.

I become online safety office ..

May everyone be safe & less crushes always.. Cheers!

[misato]

Bro.. just to gentle reminder for safety .. kindly unplug one of the wire from ESC to Motor or Kindly remove the blades form rotor head.. during binding process or if you are making changes for the setting with TX. PLs DO not ask why! .. happen to me with my Belt CP V2. luckily that time I took out blades.

I become online safety office ..

May everyone be safe & less crushes always.. Cheers!

I would prefer to shift the motor out a bit so its gear is not in contact with the main gear.

[RC_999]

I would prefer to shift the motor out a bit so its gear is not in contact with the main gear.

Great idea .. but KDS 450SV, if he want to touch the motor's screw he need to remove battery tray for sure .. weak engineering over trex 450 or clone. Very trouble some .. trust me! .. no tools can go in to touch the screw.

The best is unplug the one of the ESC wire, if he is not testing the rotor head.