I accidentally discharge my 11.1V lipo to just 3V.

[LittleGiant]

There was no bloating. I charged the battery using Esky charger. The full charge voltage was the same as before.

I tried the pack and the power was as good as before. Run time was also the same as before.

Does this mean that my lipo is alrite?

Using Etec 1800mah 3 cell lipo rated 10C continous.

On another note, I bought some HXT 180mah single cell lipos and arranged them into 2 cell setup for my micro-t.

But the thing is as I wasn't using a lipo cut off, I always run the micro-t until the battery can no longer supply juice to the motor which is about 4v. I've done this for 5 - 6 cycles already and each time the run time and the power is still the same. M I damagaing the battery in anyway?

[Hazy]

Kipo don't live long on anything below 3V.So just remember don't over discharge your batt next ime.

[LittleGiant]

Kipo don't live long on anything below 3V.So just remember don't over discharge your batt next ime.

Hmmm I plan to an experiment. I will keep discharging my 180mah lipo to 4V then fully charge it. I wanna know how many cycles it can survive.