Ecube charger Power setup for lipo 5200mah 6s

[Bijay]

Ok. Thank you.

[nb8686]

You can google/youtube on how to rescue a flat Lipo battery.
There is some risk involved if you are not really familiar with Lipo batteries.

Although you may be able to use the battery (after the rescue), but it can never be in the same healthy state again.
It depends on how low the battery was discharged, and how long it stayed at that state.

[Bijay]

All right. Then I need new battery for that?

[nb8686]

Hi !
Now this time I try to charge 1300 mah battery, It says battery low voltage.

Your battery may have over discharged during your heli setup tests.

Normally, you should not discharge a lipo battery cell to below 3.7V (i.e. 11.1V for a 3S)

If a lipo battery cell is discharged below around 3V (i.e. 9V for a 3S), there will be some damages to the battery.

If a lipo battery cell is discharged below around 2V (i.e. 6V ofr a 3S), the battery is as good as gone.

[nb8686]

I think I need this cable.

Yes.

[Bijay]

Hi !
Now this time I try to charge 1300 mah battery, It says battery low voltage.

[Bijay]

Thanks. Done it finally.

[Bijay]

Now it says “cell count error”.

[Bijay]

I think I need this cable.

[Bijay]

I think I need another cable to join it to the charger. That’s all I got.

[nb8686]

You need to connect the main cable of the battery (the yellow connector with the red/black cable) to the charger.
This is the main charging connection.

[Bijay]

[nb8686]

Please post photos of your wiring (between your charger and battery) and setup.

You can try lower the current further, say 3A.

[Bijay]

Process Interruption.

[Bijay]

Hi,
Yes I have connected and changed every thing. Still says Proceess Process.