FS: FEDA on separate w Hornet FP blade

[HZM]

Selling my FEDA on separate c/w

Stock FEDA w cupid Ball in swash

Hornet FP blade ( See next pic )
Newly replaced GWS main gear w shaft
Newly replaced Graupner speed 300 main motor
Newly replaced B2C tail motor
VS-6 x 2 (6g servo)
CSM 200 HH gyro
ICS 100 for main
ICS 50 for tail
Colco Landing skid


Selling $300, add $30 for GWS 6 Ch rx on 72mhz

Mike

[HZM]

1 more pic w all blade

1st set is MS hornet fiber glass blade.. condition quite bad but no prob flying. Need some fiber glass cloth to reinforce.

2nd set is MS hornet carbon fiber blade bought fr local member. Mint condition, like 1-2 flight on ground only

3rd set is stock FEDA blade w chip at end

[HZM]

Decide to separate this creature


Heli frame w colco landing gear and stock blade - $85 neg.
( w chip at corner but flyable )
Newly replaced GWS main gear w shaft
Newly replaced Graupner speed 300 main motor
Newly replaced B2C tail motor



CSM HLG200 with Heading Lock - Lightened Version - $105 - SOLD
( Going for US$89.00 at helihobby ) Wire had been changed to 32AUW.


Pretty bad condition FP hornet blade white - $17
( Need some repairing else track ok. Better than stock blade even in this condition no joke )

Can also reach me at 92718979

[HZM]

Close up condition of the Hornet FP blade .... no joke, for its condition, its better than those stock blade U need to use fiber glass cloth to reinforce it over to prolong the life span.

Cheers

Mike

[HZM]

1 more

[fIShCaKe]

ZZZZZZZZZZZ...... how could ya tear ya bird apart?!

sigh.

[HZM]

Originally posted by fIShCaKe
ZZZZZZZZZZZ...... how could ya tear ya bird apart?!

sigh.

Sigh...... Long story short - Xiao Ma 's fault ....... showing me the DSLR ......


Anyway, a quick update:-

FEDA frame w colco landing gear w cupid Ball in swash - $85 neg

or

Trade w Himaxx brushless / Feigo etc ......

Pls note the frame comes w new main motor, tail motor and main shaft. Also have GWS ESC ICS-50 & ICS-100 if you plan to go separate.

Will consider any reasonable offer $20 not reasonable hor .......

Mike

[HZM]

Originally posted by HZM
Sigh...... Long story short - Xiao Ma 's fault ....... showing me the DSLR ......


Anyway, a quick update:-

FEDA frame w colco landing gear w cupid Ball in swash - $85 neg

or

Trade w Himaxx brushless / Feigo etc ......

Pls note the frame comes w new main motor, tail motor and main shaft. Also have GWS ESC ICS-50 & ICS-100 if you plan to go separate.

Will consider any reasonable offer $20 not reasonable hor .......

Mike

Sorry guys.... its gone ........

Mike