Glue for Foam plane

[ford69]

I would like to buy the glue suitable for repairing foam plane. Any1 has or can advise where to get? Preferably near Northern Spore will be good.

Thks
Newbie never even fly the plane yet

[hoppie]

use Epoxy, it comes in 2 bottle u mix and use it. harden in 6min

[baby_zyklon]

UHU por. Can get at artfriend.

[ford69]

UHU por?? Izzit those u find in stationary store?

[ford69]

Where to get the epoxy type? Near northern side of spore have?

[hoppie]

Where to get the epoxy type? Near northern side of spore have?

hardware shop shld have. if not go to those shopping center with DIY store

[hoppie]

dun think UHU will work. All the modeler use Epoxy i suppose. Can stick the bloody 2 wings together after broken into half! Tested and proven within 10mins fly to the sky again!

[ford69]

Thanks

[HotDogBun]

UHU POR works well with Foam. Tested on my Formosa & Zoom Zoom. It is actually very strong, and not as brittle as epoxy or CA. Only bad point is it takes a super long time to harden & dry up. I usually leave my parts overnight when I use UHU POR.
If use epoxy, better to get 15 min ones. Those 5 min ones do not really give you much time to recorrect your alignment as they cure very fast.

[flyg]

UHU Por works well. Dont really take 'very' long to cure.

Method of applying is to put glue on surface to join. Let is dry for about 10 - 15min. Then join the parts together & hold for about 30sec to 1 min.

After that should be done. For complete curing, leave to for about 2 hr or so.

However, do dislike the 'spider web' it causes.