hi, currently i hav 2 servos with Futaba connectors. But i'm using a Hitec rx. How do i go about connectin them, just get JR/Hitec connectors then cut off the Futaba ones & tape them? Or i need to solder the wires to the connectors?
Announcement
Collapse
No announcement yet.
how to change servo connector
Collapse
X
-
I do not see Futaba connector before but I believe it should be the same type of pins. With that, 2 ways u can do:
1 - Slowly and carefully take out the metal pin out from the plastic connector (can release by carefully lift up the latch and pull it out). Then rearrange the wire direction to be in Hitec connector type (That is, Black Red and Orange)
2 - Take out the pins and put it onto the Hitec connector.
Super-Hornet
Comment