Sanwa RD8000 "INIT" accidentally in SRV mode

[syte]

I accidentaly hit the INIT key while in service mode on the SANWA RD8000, so upon turning the unit on, it has ERR2/ERR1 mode. I got to the NEU and TRV menu to try to reset the controls, but now it has a throttle Hi! warning.

Does anyone here know how to calibrate the neutral and travel positions? in Neu, there are some LCD that shows like this

O O
_ _

where do you position the sticks?

and in TRV mode, there are some other signs and i am not how to move them.

what i do remember is in A/D menu, all the potential numbers are 0 whilst the sticks are in neutral. now they are showing some numbers in the range of 127 or so.

thanks in advance.

[MicroHeli-Nut]

Dude,
I've got into the same problem before. But I can help you more specifically if u draw out the full diagram, because there are two screens to this and I'm not sure if it's to move the sticks to extreme travel or center them.

[HZM]

I think "Sanwa Wong" can help....probably chargeable.




Mike