Ar6210 elevon mixing servo arm movement range problem

[Mana]

hi,

i'm a beginner, I had my left servo connected to my Aux 1 and right servo to the aileron chn.

Im using dx6i to setup the wingtail mix to activate Dual Aileron, then i went to Mix 1 to activate ELEV > FLAP both rate set to 125% to setup my elevon.

When i done everything i try to move the stick my servo movement range isnt equal up and down.

How to setup the servo arm movement range for same amount of angle for up and down?

[gpsnuts]

Check your setting again. When you change the travel setting to 125%. You should change it for both direction.. move the stick and you can see the arrow changes direction.