T E A M
Hi all, i have some problems with my hobbywing pentium esc, what my throttle stick is at 1/2-3/4, the motor would be spinning at full throttle. So i was just wondering, is it possible to program the esc such that the motor will spin at the correct rpm where ever the throttle stick may be. (i did not touch any of my esc settings.)
-
-
so happen to answer some question on hobby wing esc jus now..
think you are referring to >Throttle range setting.
1. Switch on transmitter, move throttle stick to top.
Connect battery pack to ESC, and wait for about 2 seconds.
“Beep-Beep-” tone should be emitted,
means throttle range highest point has been correctly confirmed
2. Move throttle stick to the bottom,
several “beep-” tones should be emitted,
presenting the number of battery cells
A long “Beep-” tone should be emitted,
means throttle range lowest point has been correctly confirmed
you can check out the prog guide here also..
http://www.hobbywing.com/upload/manual/ESC_e.pdf -
Thank you so much. Its working perfectly now.Comment
Comment