2.4 wireless camera TT

[doraemonboy]

juz wondering anyone out there have these wireless camera..
coz mine really sux..
i place it on a glider,upon launching,they goes..the stable screen became flickering all over troughout the whole flight!!i'm using spektrum rx-fyi
its really waste of money
its my point of view..
hope to hear from you guys who have purchased the same item from rotor.
item:http://shop.rotor.com.sg/show-detail.asp?prodid={891E8F56-0BBF-4F83-9AC8-167F91DA36AE}&pn=

[etman]

juz wondering anyone out there have these wireless camera..
coz mine really sux..
i place it on a glider,upon launching,they goes..the stable screen became flickering all over troughout the whole flight!!i'm using spektrum rx-fyi
its really waste of money
its my point of view..
hope to hear from you guys who have purchased the same item from rotor.
item:http://shop.rotor.com.sg/show-detail.asp?prodid={891E8F56-0BBF-4F83-9AC8-167F91DA36AE}&pn=

Bro,

Sorry to hear that. I had similar experience buying a cheap security cam product and tried to use for FPV.

Actually the specs did not say for FPV flying. I would not expect this system to enable one to fly by FPV. Only for land use. i.e. car or boat.

[etman]

Also, 2.4 RC with 2.4 video is a no no.
Maybe you can sell it off to a car enthusiast.

[AP 4 T]

juz wondering anyone out there have these wireless camera..
coz mine really sux..
i place it on a glider,upon launching,they goes..the stable screen became flickering all over troughout the whole flight!!i'm using spektrum rx-fyi
its really waste of money
its my point of view..
hope to hear from you guys who have purchased the same item from rotor.
item:http://shop.rotor.com.sg/show-detail.asp?prodid={891E8F56-0BBF-4F83-9AC8-167F91DA36AE}&pn=

Maybe my glider to fast for ur camera lah bro

[doraemonboy]

Also, 2.4 RC with 2.4 video is a no no.
Maybe you can sell it off to a car enthusiast.

thks...

[LittleGiant]

thks...

2.4 with 2.4 should be ok because 2.4 modules are designed to jump channels automactically.

Wat I suspect is that the camera is too near to the motor. u can do a test. Just move the servos and see if the image is flickering. Remove the blades and try spinning up the motor and see if it flickers too.

[doraemonboy]

2.4 with 2.4 should be ok because 2.4 modules are designed to jump channels automactically.

Wat I suspect is that the camera is too near to the motor. u can do a test. Just move the servos and see if the image is flickering. Remove the blades and try spinning up the motor and see if it flickers too.

thks..
But still the same..
Ive even place the cam at the nose of my paraplane which is totally free frm servos,motor..
Result=Still the the same..
Basically the whole tt 2.4wireless cam sux..

[Abdul]

2.4G wireless camera

What is the wireless camera RF power output ?
Look at the spec.
Don't expect much from those cheap security wireless CMOS camera with RF power of 10mw.

There are many 2.4G Tx with power ranges from 50 to 5000mw
For a 200mw Tx power, you may get a line of sight range of 500m.

For longer range, you have to consider the size, weight and the Power consumption to operate the Tx camera. You also have to decide on the camera sensor type either CMOS or CCD, The camera lens wide angle and many more......

Easy and sure way is get those model tested by member here.


Thanks

[etman]

2.4 with 2.4 should be ok because 2.4 modules are designed to jump channels automactically.

Wat I suspect is that the camera is too near to the motor. u can do a test. Just move the servos and see if the image is flickering. Remove the blades and try spinning up the motor and see if it flickers too.

Not true, even if can jump, it will still have interference from WIFI, other 2.4 radios, etc. Worse it may cause interference with other flier's 2.4 radio. but then again the TX is only a small powered 10 mW.

In general 2.4 video not good for outdoor and with heavy 2.4 noise.
I tried before and it sucked.

[Abdul]

2.4g

Not true, even if can jump, it will still have interference from WIFI, other 2.4 radios, etc. Worse it may cause interference with other flier's 2.4 radio. but then again the TX is only a small powered 10 mW.

In general 2.4 video not good for outdoor and with heavy 2.4 noise.
I tried before and it sucked.

Try Aurora 9 Tx, under the scan mode, it will select the clean channels and skip the congested channel.

Thanks