Tx and RX binding

[Cklasse]

Has anyone encountered his Rx light blinking even after binding?
Will force moving servo horn when power to the Rx is off damage anything? I did this and the RX light starts to blink when I turn on TX and Rx, servo refuse to go back to 90 degrees as set before this problem.

[wantime]

Has anyone encountered his Rx light blinking even after binding?
Will force moving servo horn when power to the Rx is off damage anything? I did this and the RX light starts to blink when I turn on TX and Rx, servo refuse to go back to 90 degrees as set before this problem.

Sometimes it happens to me too. wat i did was to switch off the tx n rx. put the tx a bit further( an arm's length or so ) away from the rx n switch dem on again. tt fix my blinking prob.
Hv u tried binding dem again??
it may b yr rx is not receiving a signal from yr tx or is experiencing low voltage, n it sets n moves yr servos to a failsafe position.