NOTE !! Burned Align DS420 Servo by ESC setup.

pakkua80

Senior Member

Join Date: Nov 2004

Posts: 825
#1

NOTE !! Burned Align DS420 Servo by ESC setup.

18-01-2009, 10:13 PM

Hi Guys,

Please take note of the current setup with the Align GP 750 Gyro with the DS420 Servo. It will burn the DS420 servo for unknown reason. Please set the ESC output voltage to 5V. Please refer the following websites.

Warning. ESC and Tail Servo Overheating problems. - HeliFreak

http://www.helifreak.com/showthread.php?t=104153

I have seen a few post where overheating of the ESC and Rudder servo. In my case, I just programming the gyro and setting the rudder servo..I noticed

Tail belt fraying after 2 mins of hover.... - HeliFreak

http://www.helifreak.com/showthread.php?t=112549

Hi all, During setup, I checked my belt tension and it was quite loose. So I tightened it to the recommended 'finger test' tension and then spun the

http://bbs.alignrc.com.cn/redirect.php?tid=74&goto=lastpost

From reading all this, there is more to this problem.

------------------------------------

[SIGPIC][/SIGPIC]
Tags: None

Announcement