Hi guys, I'm using an INO-Lab HG-D261HB servo for my GY401 gyro.
The servo gets very hot after flight, so hot that it feels uncomfortable to touch it, but will not burn your fingers, is it normal for this servo?
I've check there's no binding on my tail and gyro has been setup properly.
I also cannot get my tail to stay rock solid in HH mode, the tail always drift to the left.
I'm running on 6V on this servo.
Any advise?
Thanks
The servo gets very hot after flight, so hot that it feels uncomfortable to touch it, but will not burn your fingers, is it normal for this servo?
I've check there's no binding on my tail and gyro has been setup properly.
I also cannot get my tail to stay rock solid in HH mode, the tail always drift to the left.
I'm running on 6V on this servo.
Any advise?
Thanks
Comment