servos on plane

[calvin]

building a edge 540 nitro one.got stuck with the servo thing.
the elevator uses 2 servos.according to the mannual, both servos is on the rear side of the fuselage almost near the elevator and when i installed the servo to the fuselage side and use a y cable,both the servos wont syn tat means 1 go up and 1 go down instead of both going upwards.how to make it both go up ha?had try wif different channels in my dx 7 but still couldnt work.
any experience flyers can help?thks

[khpan2003]

is both the servo oritation correct? both servo arm pointing the rear or opt each other?

[calvin]

is both the servo oritation correct? both servo arm pointing the rear or opt each other?

both pointing downwards.

[khpan2003]

if both pointing downward.. they will move in opt direction...
should be one up one down

[romihensem]

hmmm

u can try one of these options.

1. u can try using individual channels for both servo and do the mixing from there. meaning 1 servo +100 next servo is -100 by using channel 1 and 6.

2. u can use y harness but need to switch the servo arm over. but u cant trim each servo individually by using this method.

hope this helps