I borrowed from a friend brand new Futaba S3154 servo n had just install it in my T-rex 450SE as rudder with my Futaba GY401 few days back.I tried to test flight this morning.But shet!U know wat happen?The servo get burned up on my 1st flight when i attemp to do flip!
SHET!I cant believe it!How could this happen?I tot it will only have this problem if u r using it on a 6V setting?It cause my heli for a crash but luckily no major things was broken,only landing skid broke!
But the problem is,how could i trust this servo again in the future?It burned up till the whole servo case melt n alot of smoke came out from the servo while my heli was landing!
Here are my setting:-
-T-Rex 450SE
-Align 430L 3550kv motor
-Emax 40A ESC(4.8V)
-Futaba GY401 gyro
I tot there will be no problem for this setting?
It never happened when i was using Hitec HS50 for my tail(NEVER)!
Just wanna ask can i make a complain to Futaba Website regarding this issue?
I felt disappointing n mad about this issue!REALLY MAD!
SHET!I cant believe it!How could this happen?I tot it will only have this problem if u r using it on a 6V setting?It cause my heli for a crash but luckily no major things was broken,only landing skid broke!
But the problem is,how could i trust this servo again in the future?It burned up till the whole servo case melt n alot of smoke came out from the servo while my heli was landing!
Here are my setting:-
-T-Rex 450SE
-Align 430L 3550kv motor
-Emax 40A ESC(4.8V)
-Futaba GY401 gyro
I tot there will be no problem for this setting?
It never happened when i was using Hitec HS50 for my tail(NEVER)!
Just wanna ask can i make a complain to Futaba Website regarding this issue?
I felt disappointing n mad about this issue!REALLY MAD!
Comment