Turnigy Mirco Quad V2 PNP ARF includes KK2.0 LCD Flight Control Board

[mit_evo]

Hi,

Am new and I recently bought a Turnigy Mirco Quad.

Need help/advice how to set up this Quad with my DX6I..

Thank you..

[timgoh0]

Should be relatively straightforward: hook up your rx to the KK flight control as seen in [1], run the cal process as seen in [2], and off you go. Then it's PID tuning time.

Make VERY sure you have no props mounted during the calibration process. If the ESCs decide that it's not in cal mode, all the motors go to full speed. This would be unfortunate if your finger is in the way.

[1] http://www.hobbyking.com/hobbyking/s...30X7478X47.pdf
[2] http://www.hobbyking.com/hobbyking/s...X777308X32.txt