Calling all Night Owls

[iz77]

Oic, Thursday is starting of my shift and alternate wed.

I am a newbie in flying quads. I try Heli few years back but gave up after few months of trying to tune it. And stay grounded rc hobby only. But now after going thru the forum and saw this forum, I was so eager to try it but been stuck with calibrating the TX to the NAza.

Ok let start,

1st, I'm not sure if my 9xr TX follow which type of configuration, jr, futaba normal pins setting or a_ bus setting?

2ND, I tried normal futaba n jr setting but can't find the plane mode in my TX. I thing my previous turnigy 9x got that type of selection but not in 9xr.

Hope all the pros can help me with this issue.

Anyway thanks in advance.....

[quadflyer]

Hi iz77, I use Futaba 8J so I can't help with the details but the general set-up should be the same regardless of the RC brand & type.

The Tx needs to be in aero or plane mode (not heli)

follow the channel connections in the wiring diagram in the naza manual (download from DJI website)

check the Tx the channels correspond to the rx & naza channels using the naza assistant software. Throttle moves the throttle, rudder moves the rudder etc.

I hope this helps you get started.