Need Help On My Honey Bee crash

[ChRiS]

my fren crashed my heli!!
he act smart say noe how to fly then lend him... he flewe it too close to the wall and !!!
now got a few probs

1) dunno if main shaft is bent?? coz i dunno how to check...

2) the flybar snapped & i dunno wat tools to use to loosen the flbar to take it out? it snapped right at the tip of the weight juz before the paddles... so i dunno how to take it out and i oso dunno how to take the flybar our of the heli?

PLZ help

[pilot_bear]

hold the heli, throttle at ver low speed for rough check, see the blade at eye level (not too close!!!) , if everything is ok, you will see one sharp image of your rotor head or (the screw), , if you see a blurr image, then
for a better check, remove the shaft and place it on a flat surface, e.g. glass, and roll it, smooth means its ok

can also follow the link,

http://www.daddyhobby.com/forum/showthread.php?t=4678

for the flybar, use the allen key that is provided, the same allen key for tightening the blade to the blade clamp. you will have to lossen all 4 nuts, a bit of force is need at the paddle control frame because of the plastic.

btw, try to remove yr flybar first, and check for other problem , then buy your replacement together, save time.

before tightening the 4 nuts, Remember to center the flybar and paddle or your heli will again

Good luck and hope the heli will be flying very soon.