anyone have vibration prob on copter X

[jansonfinn]

so i need to change the main shaft?
is there any other thing that will coz the whole heli vibrate?

u can try bro heli_fanatic suggestion by tightening the blades 1st, following by checking for tracking problem.

If problem is still unsolved, try changing the main shaft

[johndyl]

try loosening the blades if it is already very tight. balance the blades and also make sure both have equal tightness

[HotDogBun]

The main blades do not need to be tight.
Rule of thumb I use is to hold heli sideways with main blades stretched out.
Tighten to such extent its enough to hold the blades straight and not drop down.
Do note the CopterX's maingrips may be too loose for Rotortech blades. I added a spacer each to make sure there is no gap. Overtightening will stress the grips and cause wobbly.
End of day it is advisable to ask someone experienced to take a look.

[bobby]

The main blades do not need to be tight.
Rule of thumb I use is to hold heli sideways with main blades stretched out.
Tighten to such extent its enough to hold the blades straight and not drop down.
Do note the CopterX's maingrips may be too loose for Rotortech blades. I added a spacer each to make sure there is no gap. Overtightening will stress the grips and cause wobbly.
End of day it is advisable to ask someone experienced to take a look.

ok thkz
will try all the advice tomorrow .
if still not solve will ask someone experienced.

Thkz

[bobby]

solved!!!
is not coz of the tighten of the blade
is becuse of the main gear .

[chngee]

Vibration

What happen to the main gear? loose?

[bobby]

What happen to the main gear? loose?

the main gear is wobbly.
anyway thanks HotDogBun for helping me