Mini-Titan/CC45/Stock BL Motor

[Hazy]

This is whats happening.
-Airtechic RX
-401 gyro
-4 x HS65 servos
-CC45

*When I power up, all the servos will glitch slightly, sometimes violently.
*401 will blink, then maintain LED when HL initialised. But after that it will blink frequently even without any input from rudder stick.
*Sometimes motor will spool up suddenly during glitch.
*I stretched out RX antenna and take out all the connections and don't bundle the wires, still have glitch.
*Changed rx crystal still have glitch.
*When I unplug Gyro connectors, no glitch.

So can I safely say its more likely the Gyro having problem and not the RX?

Try to collapse your Ant and walk a few steps away from your Optic 6.I have this glitch when Optic is to near to my heli or reciever.This sound stupid but it works for me.

[HotDogBun]

I'm getting another RX later. Tonight can try out. Hope its not the gyro. Something about 401 gyro.
When no input on rudder its a steady light, reflected in manual also.
But when I trottle up, its a double flash, which in manual states that the signal from tx is different from one during initialisation.
I'm puzzled...

[HotDogBun]

Also just found out,
say if I power up and initialise in NORM mode, after stablise and no flashing red LED, when I switch to Idle1 or 2, the LED on gyro keeps having doubleflash. Is this normal??

[Hazy]

Also just found out,
say if I power up and initialise in NORM mode, after stablise and no flashing red LED, when I switch to Idle1 or 2, the LED on gyro keeps having doubleflash. Is this normal??

You must power up in HH mode for GY401.If it is correct,the led will stay.If you power in normal mode,the led flashes about 2 time than black off.It is to alarm the owner to repower again in HH mode before going into normal mode.