GY240 tail servo binding

[detach8]

My tail servo binds when using GY240. Is there any way to prevent it from binding? I reduced the horn throws but that reduced the sensitivity as well.

[Fit]

Its normal for it to bind on the ground.
Dont worry, when in flight, it wont hit the the ends of
the slider travel.

When setting up the tail, leave the ATVS/EPAS at 100/100 and leave the
D/R to 100 as well. Then proceed to setting up the tail.

In flight, increase or decrease the ATVs to get the piro rate
that you want. The servo wont bind in flight.

[detach8]

Thanks for the tip bro
Another qn: Which hole do you use on the horn? Is it better to go inwards or outwards?

[junyang]

too inwards too little throw

[detach8]

hehe jy there's an online vid and it suggested using inner hold for "resolution" so.. i mean.. dunno lah. get general feedback.

[junyang]

yah with resolution, u get lesser throw...
with more throw, you get lesser resolution..

in the middle is the best lor..