Newbie need help- Lama V3 lifts and tilts

[kimswee]

Hi All

Need some expert advise.

My lama V3 is not lifting properly. It tilts to the right and drifts backward when full throttle is applied. Please help.....

I am on mode 1 for this heli.

[HeLiCrAz]

Hi All

Need some expert advise.

My lama V3 is not lifting properly. It tilts to the right and drifts backward when full throttle is applied. Please help.....

I am on mode 1 for this heli.

Ur staying in the east?I also have Lama.Maybe i can help u.If u want,can call me & we'll meet up .

96519599

[ammo]

does the transmitter trim helps?

[Matt]

hi if the trim tabs on the transmitter are all the way over and still going to one side, adjust the servos on the heli by taking out the screw and placing the servo horn up or down more to where your heli stays straight. first make all the trim tabs straight then adjust.

ok so your heli drifts to the right take the right servo horn and place it 2 or 3 rivets higher. and get the servo on the left and place it 2 or 3 rivets lower. make sure you place each side the same such as if you want to place it 3 rivets higher on the right make is 3 rivets down on the left.

i hope this helps. if it doesn't ill post some pics maby if i have time.

[Ghostfit]

Rivets ? ....

[Matt]

rivets i mean the little groves ill take a pic an explane later

[Ghostfit]

OH !!! ...You mean THREADS ! ....little screw threads !

[hdellk]

hi if the trim tabs on the transmitter are all the way over and still going to one side, adjust the servos on the heli by taking out the screw and placing the servo horn up or down more to where your heli stays straight. first make all the trim tabs straight then adjust.

ok so your heli drifts to the right take the right servo horn and place it 2 or 3 rivets higher. and get the servo on the left and place it 2 or 3 rivets lower. make sure you place each side the same such as if you want to place it 3 rivets higher on the right make is 3 rivets down on the left.

i hope this helps. if it doesn't ill post some pics maby if i have time.

On the Lama V3, the right servo controls the aileron and the left controls the elevator. ( or maybe it the other way, don't have my lama to look at now )
Anyway, I don't understand why you want to adjust both servo to solve one axis problem?

[Matt]

oh woops i thought that both servos moved when you use aileron in that case only touch the right servo make it higher, or extend the servo link

[kimswee]

Thanks all for the advise and replies.

I will try 1 change ata time and sees if it helps.

Will post again soon on the outcome.


Ig

[kimswee]

Thanks all for the advise and replies.

I will try 1 change ata time and sees if it helps.

Will post again soon on the outcome.


Ig

Thanks everyone, my heli is now hovering and starting to make turns as well.

Ig