Announcement
Collapse
No announcement yet.
OK Model/Pilot - Nutmeg 2 Build
Collapse
X
-
Last edited by mathsinstrument; 25-12-2008, 11:47 PM.Losers whine about their best. Winners date the Prom Queen.
Most people talk a lot, only few are up for the moment.
Suck Squeeze Bang Blow20,000 times a min
Comment
-
Originally posted by mathsinstrument View PostSeriously running out of ...Storage space !
Comment
-
Finally i have the time to sit down and get some work done on my nutmeg build again....
Here's the inboard wings....
Lay out all the pieces which are required for assembly. As usual, i have completed the other half, hence I am able to build it reverse without much reference to the plans which are printed on the other side.
Trial fit to make sure that everything goes where they are supposed to go.
A closeup of the wing joiner area.
Losers whine about their best. Winners date the Prom Queen.
Most people talk a lot, only few are up for the moment.
Suck Squeeze Bang Blow20,000 times a min
Comment
-
I have to apologize for the intermediate builds because my phone batt went low...
The wings almost completed before sheeting.
I took it out of the formers quite quickly before sheeting, So I hope that it is straight.... The sheeting should be already almost completed before removing it out from the formers as to reduce the warping as far as possible.
The wing joiner tubes are epoxied into place.
So far so good... Most likely the servos will be next, together with the ailerons and spoilers. I did not install the linkages which are used on the spoiler because they are using rubber bands and strings. When the rubber bands degrade over time or storage, they lose their elasticity and crap out, so i am installing a servo to control the spoilers separately.Losers whine about their best. Winners date the Prom Queen.
Most people talk a lot, only few are up for the moment.
Suck Squeeze Bang Blow20,000 times a min
Comment
-
Hi,
I saw that there is also a slightly cheaper verison - Nutmeg #1 in SHS. Except for the vertical fin, there were only slight difference.
Was there a reason that you went for the #2?
Have anyone booked the plans after you have completed the build? If not, can I 'borrow' the plans?
Thanks.
MS
Comment
-
Originally posted by durex View PostThe difference between Nutmeg #1 and #2 is the #2 has aileron. Correct ne if I'm wrong.
The nutmeg 2 has rudder, elevator, spoilers and ailerons...Losers whine about their best. Winners date the Prom Queen.
Most people talk a lot, only few are up for the moment.
Suck Squeeze Bang Blow20,000 times a min
Comment
-
hhmm... well i dunt see any ailerons
Originally posted by mathsinstrument View PostThe nutmeg 1 has only rudder, elevator and spoilers.
The nutmeg 2 has rudder, elevator, spoilers and ailerons...
-alexander
Comment
Comment