Ultimate-E Bipe by OK model

[bozora]

Build this last weekend, Stable flight

But I have problems with mounting the stock spinner. the 3mm shaft adaptor keep popping out from the motor's 3mm main shaft each time I throttle. No choice but to use the original shaft adaptor that come with the tahmazo motor.

Any idea how to lock the adaptor shaft in place? HELP!!!

[joed]

Nice plane is it from SHS?

[Syphonics]

Nice plane is it from SHS?

i think i seen one in SHS as well, very nice build plane

[bozora]

Ultimate E

Yup, this bipe's from Sing Hobby. The parts quality's good- covering is well done, canopy pre-cut and mounted, etc.

The instructions are super detailed, part Japanese, part English, quite similar to instruction guide found in Tamiya RCcars.

But price is alittle steep.

[Syphonics]

able to reveal the price?

[HZM]

Its around 230+ I think all agreed the quality is top notch Cute little plane ....

Mike

[bozora]

The kit is about 260++, without bl motor. But I think it's well worthit.

If I compare pricing between OK models (Balsa) and Alfa models(foam base, which cost 230++, but flies just as beautiful) - i'll pick the OK models anytime.

May get the BD-5e (James Bond lookalike lowwing) by OK models to try - freakily cool looking.

[loyn]

Hi may I know what motor are u using ?

Very nice model saw it at SHS but the price stop me dead on the track

[bozora]

Hi Loyn

This is my setup

Tahmazo Outrunner ER222012 1200KV motor, motor shaft dia 3mm.
(You can use any 22 series motor with the above specs)

Prop size 8 x 6E

ESC : Align 25amp

Servos : 3 x Hitec 55, with this size of servos, it's a direct dropin with no sanding or modding.

Battery use, TP2100 or align / polyquest 1800MAH

[plug&fly]

Hi

How does it fly? Any bad tendencies? Any mods needed?

[bozora]

No mod needed, no lead weights whatsoever required, if you follow the specs I mentioned above. The CG, is spot on. Even areas requiring epoxy and CA have covering film aready removed.

This plane tracks straight, it will point where you want it. Once trimmed out, you dont even need to set expo, dr,etc.

My only grunt is that the plane should have come with a prepainted Pilot.

[P4cm4n2000]

Yo bozora,
I usually use a plier to clamp the inside rim adapter(nearer to motor), then
use a rod to tighten the spinner nut, this way, the prop adapter will grip tightly onto the 3mm shaft.

try this see if helps.

cheers! Nice plane you have...