Hi, I'm constructing an electronic braking mechanism for my project. I will be using a servo to pull a steel wire which in turns pulls the brake lever. The steel wire will go around the circumference of the servo horn like a winch. Below is a rough sketch of the mechanism:
I currently have access to a HerkuleX Smart Servo (12kgf.cm) so I will be doing some testing on that first. I was thinking of replacing the horn with a horn winch such as the Futaba Servo Horn Winch Drum FUTFSH5801:
However, I'm not sure if there is a way to attach the steel wire onto the winch. Do you guys have any idea how it works?
I currently have access to a HerkuleX Smart Servo (12kgf.cm) so I will be doing some testing on that first. I was thinking of replacing the horn with a horn winch such as the Futaba Servo Horn Winch Drum FUTFSH5801:
However, I'm not sure if there is a way to attach the steel wire onto the winch. Do you guys have any idea how it works?
Comment