Announcement

Collapse
No announcement yet.

Apache 2030 battery with Etec 1250

Collapse

Zenm Tech Pte Ltd

Collapse

Visit Zenmtech at rc.zenmtech.com

X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
    #1

    Apache 2030 battery with Etec 1250

    Usually when i charge the lipo, the light indicator would not blink and will show charging . But somehow today when I tried charging, the light showed that the battery is charging and after a few seconds shows its full.

    What do i need to do ? Discharge it fully ? it seems to power on when i put it on my plane but after a few seconds ( about 10s) the engine will die due to low battery.

    what next ? new battery ?

    Which character are you test by
    Tags: None
    #2
    Hi guys ~ Latest : when i try again, this time the Chg/Error light blinks. is my battery dead ?

    Which character are you test by

    Comment

      #3
      Originally posted by alamin2
      Hi guys ~ Latest : when i try again, this time the Chg/Error light blinks. is my battery dead ?
      Are u charging wif 12V Lead Seal Acid? Cause if thats the case the blinking light could mean that the 12V is weak.

      Comment

        #4
        Originally posted by alamin2
        Hi guys ~ Latest : when i try again, this time the Chg/Error light blinks. is my battery dead ?
        yes check your SLA if u r using that... use a voltmeter to measure. anything below 12V indicates weak batt. ur apache can charge SLA batts rite?
        Hover: STILL many many
        FF: so-so; fig 8s, nose-in hover
        Crash (Major): 4
        Back to flying... let the goods times roll

        Comment

          #5
          nope im not . Im using a 12V dc charger . I Charged another lipo and it still works so I ruled out that the DC power source and the Apache is not working . REason?

          I charged 2X Ni-cd and another Lipo which i bought today so I dont think its the charger nor Power source.

          Could it be my etec wiring ? I find that sometimes the etec isnt detected when i plugged in to charge and after adjustments than the charge light swtiches on. Im not using those dean connectors or what.. Its those normal battery connector that's red in colour .

          Should I buy a connector for the battery to retry ?

          Which character are you test by

          Comment

            #6
            Originally posted by alamin2
            nope im not . Im using a 12V dc charger . I Charged another lipo and it still works so I ruled out that the DC power source and the Apache is not working . REason?

            I charged 2X Ni-cd and another Lipo which i bought today so I dont think its the charger nor Power source.

            Could it be my etec wiring ? I find that sometimes the etec isnt detected when i plugged in to charge and after adjustments than the charge light swtiches on. Im not using those dean connectors or what.. Its those normal battery connector that's red in colour .

            Should I buy a connector for the battery to retry ?
            It is not advisable to use a 12 dc charger as a power supply for the Apache charger, unless u know for sure the it is nothing more than a regulated power supply.

            Sounds like u have bad connections between batt and charger.

            Comment

            Previous template Next
            Working...
            X