Hi all, just brought a GWS - MC2002 last night and immediately I charged my new 8.4 -350 mah battery inside my car. Since my car battery is hidden well , therefore I ask for a FREE cigarette plug from the hobby shop. First charge was o.k, it lasts about 5 mins with charging rate about 3AH. However, when I test out the new Gaofei receiver, the servos were jittery. At first I thought it could be spoilt receiver, but the battery went dead after I connect the motor directly to the battery source. So now, I still wondering is the receiver not ok or the servo jittery because of low batt. What could have happen ? Today I tried to charge my batt again. After set-up everything, I heard a "pop" sounds, therefore, it cannot charge again. I checked for everything, including priority, fuse etc. everything is o.k. What could have gone wrong again. After reading the previous mail, don't know whether it is truly a Chan's syndrome.
T E A M
| |
| a p l a c e RC&E HOBBYISTS m e e t | |
- If this is your first visit, be sure to check out the Rules and Help. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.