Hi,
anyone using mach3 with xylotex board?
my laptop died on me recently.
And after I tried to install Mach3 on a different PC, it didn't work...
The mach3 just will not communicate with the xylotex. any clue what is happening?
the controller is still "holding" the stepper motor well when I power up.
anyone using mach3 with xylotex board?
my laptop died on me recently.
And after I tried to install Mach3 on a different PC, it didn't work...
The mach3 just will not communicate with the xylotex. any clue what is happening?
the controller is still "holding" the stepper motor well when I power up.
Comment