Pre-Flight check
1. check all your screws
2. check your servos movement
3. check all the wires to see whether is there any cut on it
4. check your connection, make sure nothing is lose
5. check all the control rod
6. check the linkage to see whether is there any crack
7. check your control horn
8. make sure your wires are not to tight or to lose
9. check all the fuel tubes, even those inside your fuel tank
10. make sure there is no or not alot of free play on your head n rudder
11. make sure your Tx or Rx batts are fully charge
12. every 2 - 3 gallons check your glow plug
13. if u on belt drive, make sure the belt is not lose. For gear drive, make sure your screws on the gear is tight.
14. check for binding
15. check your gyro, make sure is not lose
On Field
1. check your radio fq n check with everyone make sure is clear
2. recheck all the linkages
3. check your radio programes, incase someone touch n change your setting
4. check your batt level
5. recheck your wires coonection, incase during trevelling the wire came lose
6. recheck your servo movement
7. check your fuel level
Starting
1. check your throttle stick
2. make sure is on normal mode
3. move all your stick to check whether all the servo moving anot
Taking off
1. rmp your engine up, don't take off first
2. check your control whether all moving anot
If all this are check u r safe to go.
If i miss out anything, feel free to add in.
1. check all your screws
2. check your servos movement
3. check all the wires to see whether is there any cut on it
4. check your connection, make sure nothing is lose
5. check all the control rod
6. check the linkage to see whether is there any crack
7. check your control horn
8. make sure your wires are not to tight or to lose
9. check all the fuel tubes, even those inside your fuel tank
10. make sure there is no or not alot of free play on your head n rudder
11. make sure your Tx or Rx batts are fully charge
12. every 2 - 3 gallons check your glow plug
13. if u on belt drive, make sure the belt is not lose. For gear drive, make sure your screws on the gear is tight.
14. check for binding
15. check your gyro, make sure is not lose
On Field
1. check your radio fq n check with everyone make sure is clear
2. recheck all the linkages
3. check your radio programes, incase someone touch n change your setting
4. check your batt level
5. recheck your wires coonection, incase during trevelling the wire came lose
6. recheck your servo movement
7. check your fuel level
Starting
1. check your throttle stick
2. make sure is on normal mode
3. move all your stick to check whether all the servo moving anot
Taking off
1. rmp your engine up, don't take off first
2. check your control whether all moving anot
If all this are check u r safe to go.
If i miss out anything, feel free to add in.
Comment