Can winnie change parts

[ofna]

Can winnie exchange parts?cos i got a pull starter from her,unopened package.But i guess someone jus infd me that i can start up the engine using my airplane 12v starter.Just need the rubber attachement(duno wats its called) .So now i having thoughts of converting my hyper21 engine to pull start.intend to trade with other stuff...issit possible?

[eleewhm]

the rubber attachment is call a "donut"...i got mine from rotor....just ask the auntie there...

[ofna]

Thanks.how much it cost?it just slips un the airplane starter?you thnk winnie allow to change and vget other stuff...?

[sspp]

Thanks.how much it cost?it just slips un the airplane starter?you thnk winnie allow to change and vget other stuff...?

the donut cost less than $10 i think. but make sure your donut is so not so thick that it cannot go into the lobang at the chassis for you to turn the flywheel.

as for changing things with winnie, i think should be ok if she is in good mood lah....hahahahahaaha

[ofna]

Err...U mean you have to shuff it in at which part?i tot you just run it agianst the gear exposed below the chasis?can i still use my 12v starter if i still have a pull starter attached?

[sspp]

Err...U mean you have to shuff it in at which part?i tot you just run it agianst the gear exposed below the chasis?can i still use my 12v starter if i still have a pull starter attached?

below the chassis must also have an opening for the donut to go in right? and yes, you can still use the 12v starter with pull starter

[ofna]

sorry...abit longwinded about this.cos so used to pullstart.not even aware my airplane starter can start cars...hahahah...iv got a pic to refer?which part?

[sspp]

[QUOTE=ofna]sorry...abit longwinded about this.cos so used to pullstart.not even aware my airplane starter can start cars...hahahah...iv got a pic to refer?which part?

the lobang with the flywheel

[ofna]

how does a starter with donut looks like??A donut looks like this?

[sspp]

how does a starter with donut looks like??A donut looks like this?

correct

[ofna]

so the donut goes trgh the starter and run it agianst the smooth part of the flywheel not the teeth part?

[sspp]

so the donut goes trgh the starter and run it agianst the smooth part of the flywheel not the teeth part?

teeth part. but the donut have to go thru that lobang to touch the teeth part

[ofna]

arrow

ignore teh arrow.so the donut looks like sort of two piece...it rub against the smooth part and the teeth part isit...

[sspp]

rubs only the teeth part not the smooth part

[ofna]

just came back from winnie.Got the remaining part for my pull starter.check with her..she say the whole starter set infront must change to suits the car one...well, in any case i will just drop by rotor to see the so call donut.Either way, i still can use my electric start or my pull start same time rite?!!!