Results 1 to 2 of 2

Thread: Mach3 and Xylotex cnc stepper motor driver

    Contribute If you enjoy reading the content here, click the below image to support our site.
    Click Here To Contribute To Our Site
  1. #1
    Gold Member
    Join Date
    Oct 2005
    Location
    punggol
    Posts
    2,077

    Mach3 and Xylotex cnc stepper motor driver

    Hi,

    anyone using mach3 with xylotex board?
    my laptop died on me recently.

    And after I tried to install Mach3 on a different PC, it didn't work...
    The mach3 just will not communicate with the xylotex. any clue what is happening?
    the controller is still "holding" the stepper motor well when I power up.

  2. #2
    Mach3 Pin assignment, pulse engine driver? I assume xylotex board is a bob?

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Advertising