Announcement

Collapse
No announcement yet.

Help with KK Mini Control Board?

Collapse

Zenm Tech Pte Ltd

Collapse

Visit Zenmtech at rc.zenmtech.com

X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Help with KK Mini Control Board?

    I'm new to RC Flying, so I'm going to post this question here

    I need some help with my KK Mini Flight Controller Board. I'm in the process of building a quadcopter, and have difficulty connecting to the receiver to the flight controller board? On the KK Mini, there is a row for input from the receiver, but unlike the full size KK, it only has 1 pin? I've been watching a lot of videos on youtube, but I can't seem to understand.

    Thank you very much for your help!

    On a side note, happy new year!

    #2
    It's pretty much the same as the bigger KK board, just that the mini has a common ground and power for the pins, which is why there wasn't any need to have them. That means you only need to connect the full 3 pins (ground, power, signal) to channel 1 of your Rx, while the rest of channels 2-5 only need the signal pin as the ground and power are shared from channel 1. If your Rx supports CPPM, you only need to connect one servo wire from the Rx to the first 3 pins of the mini KK (ground, power, PPM signal). I highly recommend the CPPM way if your Rx supports it.

    Comment

    Working...
    X