Good Tap and Die set

[adn6244]

Hi,
Anyone knows where to find good tap and die set that can make screw thread for RC use?

Thanks.

[zonerx]

basically all works the same, you can find at most of the hardware store

[adn6244]

Thanks Mike. I thought for RC use...the size is much smaller so may not be able to find easily.......

[zonerx]

what size you looking for?

[adn6244]

Maybe 2-3mm

Are these common measurement?

[HZM]

yeah, basically u still can get M2 & M2.5 tap The smallest I had is M2

If u want "Good" tap, try asking for machine tap. The are identical to hand tap but are more "sharper & durable" U don need to "back out" when taping

Cheers

Mike

[adn6244]

Thanks Mike.

I saw the Sherline mill at Winnie's place. Is your "machine" also the same size?
That's small !!

[HZM]

Slightly bigger .... higher power rating

Cheers

Mike

[VinCopter]

1mm & 1.5mm die and tap?

Any one try looking for these before?
Trying some mod on my HB.

VinCopter

[pilot_bear]

VinCopter ,
not sure if they carry 1mm to 1.5mm, but can try,
Allinton Engineering & Trading Pte Ltd
803 King George's Ave
#01-234, S(200803)
62960679

http://www.allinton.com.sg

give them a call before going down, they don't keep stock, need to call first.

Very near to Rotor.