Announcement

Collapse
No announcement yet.

connectiong servo w/o reciever

Collapse

Zenm Tech Pte Ltd

Collapse

Visit Zenmtech at rc.zenmtech.com

X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    connectiong servo w/o reciever

    Hi everyone

    is it possible for me not to connect a continuous rotating servo to a receiver, instead to a direct DC to achieve continuous rotating motion.


    if no, is there any other way to do it.

    thanks in advance

    regards
    radiation

    #2
    Full Rotation Servo

    Hi Bro,

    Not sure what you meant by a continuous rotating servo.
    Is it something that you can use for the winch of the RC sailboat or jeep?
    I made one years ago by cutting off the stopper tab on the last gear and disengaging the gear from the variable pot shaft.
    Did this by drilling to widen the hole in the gear so it rotates freely on the shaft.

    It worked fine with predictable results until I needed a gear boxed motor.
    I then disconnected the original wires from the motor to the control board and ran a new pair of wires direct to it.
    The motor ran ok on 6V DC.

    Have fun.

    Sawit

    Comment

    Working...
    X