If this is your first visit, be sure to
check out the Rules and Help. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Announcement
Collapse
No announcement yet.
How do i hook my MuiltiTester to Check Current DRAW?
correct.... but if you're testing to make sure your amp draw doesn't exceed the cell's rating, then the ampmeter should be between the batt and the esc.
Now that I think of it, I wouldn't recommend connecting the ampmeter between the esc and the motor. The ESC's output to the motor is using pulse width modulation to control the speed of the motor. The ampmeter night not read the amp draw correctly.
The reason I said so is because 1st is similar to what AceViperX said and the 2nd thing is that u are measuring the actual current drawn by motor + ESC.
Here we measure the feedback current. The advantages is that the Ampmeter's resistance will have less of an effect on the acuracy of the current reading. If you put in on the positive side, the ampmeter's resistance might cause the current being read to be lower than it really is.
-Feda Dragonfly
-Hornet 2
-Pilot OK Turmeric
-Zoom Zoom 4D
-Sceadu EVO 50: OS50, Hatori521, Revmax,
-Hornet X3D
-Hornet X3D (yet to setup!)
-Formosa 1
-World Models Spot On 50
-HB King 2
-World Models Groovy 50 F3A
-RICCS F18 EDF
Comment