I was trying to install my new OS 105 HZR and powerboost pipe. It got a bit tighter when I screwed in the mounting bolt but the mifgler was a bit loose. I tightened it further and my hex bit broke and got stuck on the bolt. Now I can’t remove this bolt. So I tried drilling and even cutting the bolt in the hope of removing it. I’m at a loss now. Tried to upload photos her but unsuccessful.Appreciate if any kind soul can lend a helping hand. TIA.
T E A M
| |
| a p l a c e RC&E HOBBYISTS m e e t | |
- If this is your first visit, be sure to check out the Rules and Help. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.