TT01 Futaba Servo?

[Tiger S33]

Is this true that once you do your first setting on your esc, the servo will automatically turn into its position?

After the servo stop turning into its position, than you do your steering adjustment is it? Is this normal?

Need quick help and answers as i am not sure whether is this malfunction or not?

[pixelshutter20]

you have to power up your servo and normally it will move to its neutral position and then you attach your servo arm. after this set up you can tune your wheels already. if there are some minor alignment problems you can always further trim it on your radio.

if you have a radio that can adjust the endpoint adjustment of the servo it would be advisable to adjust it so that you wont strain the servo...

[psychophant]

servo installation, in sequence:
1. Ensure transmitter settings are all in neutral positions.
2. connect esc and servo to receiver.
3. switch on transmitter.
4. switch on ESC.
By now, the servo should automatically move to its neutral position.
5. switch off esc.
6. switch off transmitter.
7. attach servo horn at 90degrees to the servo.
8. repeat steps 3 & 4 to reconfirm servo connection.

[Tiger S33]

Thanks, guess i do the right thing.