Lipo charge And power setup for 5200mah battery with ecube A1 charger.
Announcement
Collapse
No announcement yet.
Ecube charger Power setup for lipo 5200mah 6s
Collapse
X
-
Need to select the "Pack. Volt." to 22.2V / 6S, according to your battery.
Need to set the "Capacity" to "5200mAh", according to your battery.
Once the Capacity is set to 5200mAh, the charger will automatically suggest the charging current of 5.2A.
However, although A1 charger max charging current is 10A, but its max power is 100W.
When the cells close to fully charged, the voltage is 4.2V per cell. This means the total voltage is 25.2V (4.2V x 6).
The power is 25.2V x 5.2A = 131W, this exceeds the max power of A1.
So, you need to reduce the charging current to lower than 4A.2 Photos
-
Hi,
The current should be 3.9A, not 5.2A
Set the current at 5.2A will cause the power to exceed 100W
Pack Volt: 22.2V/6S
Capacity: 5200mAh
Current: 3.9A
End Volt: 4.2V/Cell (fixed value for all Lipo batteries, nothing to do with no of of cells or capacity)
CHG Mode: Balance
Also, do you connect the balance cable of the battery to the charger ?
Comment
Comment