T E A M
I like to mill 0.5mm off a pan car chassis shown in the attached pic.
Basically, it is a section of 22mm x 12~13mm.
Can someone advise what is the best way to get it done ?
will dremel do the job or if there is any paid service available somewhere ?
Many thanks. <br> <br>
Basically, it is a section of 22mm x 12~13mm.
Can someone advise what is the best way to get it done ?
will dremel do the job or if there is any paid service available somewhere ?
Many thanks. <br> <br>
Attached Files