[URGENT] DJI Phantom 2 Vision Landing Gear Design

[Liu_PL]

As we all know, the distance between the camera and the ground is about 2cm +.

here comes the problem
when the DJI is landing and the ground is not flat / perfectly flat, the camera will get hit and it might tilt to the other side or damage the camera.

So I'm thinking of using SketchUp to design a longer landing gear

and 3D print it by using Mankati.

What do you guys think ?

Need some feedback. I'm doing this for my internship company.

Thanks !

[chly3001]

it will work. there are many after market landing gears that are longer or landing gear extensions, as long as it doesn't add too much weight it should be great

[Adrianli]

Why not use those cheap swimming pool floatation tubes and just attach to the landing skids? Just use penknife and cut it to size, then cut one side open, slip ur landing skids in, cable tie it close. Ta daaaaa. u just increased ur land skid height and added a soft landing pad for those uneven surfaces. Also these tubes are made of foam and very light.

I use them in my boats for floatation.