Announcement

Collapse
No announcement yet.

Need help with Walkera Rx1002 and Robird G31 setup

Collapse

Zenm Tech Pte Ltd

Collapse

Visit Zenmtech at rc.zenmtech.com

X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Need help with Walkera Rx1002 and Robird G31 setup

    Hi bros

    Was trying to setup the Robird G31 using the Walkera Rx1002 receiver. In the Robird software, it can only detect the throttle. No elevator, no aileron, no rudder. I connected the Robird to the receiver as follow:
    ELEV : connect the elevator on G31
    AILE : connected the aileron on G31
    THRO : connected the ESC
    RUDD : connected to RUDD on G31
    GEAR: nothing connected here
    AUX 1 : connected red plug from 3-in-1 on gain/pit on G31
    AUX 2 : connected white plug from 3-in-1 cable on gain/pit on G31

    Anybody has experienced this before? Tks much for your help.

    David

    #2
    Try white to gear, red to Aux 1. If cannot, reverse them, red to gear, white to Aux 1.

    Comment


      #3
      1. Make sure the polarity of the leads is correct (i.e. the -,+,s) between the RX1002 and the FBL controller.

      2. Connect a servo into the RX1002 on all the channels that have problem to see if the problem is coming from the RX.

      3. Check continuity of each of the leads to make sure current can pass through each.

      Comment


        #4
        Hi bros. Problem solved after I rebind the receiver. Tks for your advice.

        Comment

        Working...
        X