Hi bros
Was trying to setup the Robird G31 using the Walkera Rx1002 receiver. In the Robird software, it can only detect the throttle. No elevator, no aileron, no rudder. I connected the Robird to the receiver as follow:
ELEV : connect the elevator on G31
AILE : connected the aileron on G31
THRO : connected the ESC
RUDD : connected to RUDD on G31
GEAR: nothing connected here
AUX 1 : connected red plug from 3-in-1 on gain/pit on G31
AUX 2 : connected white plug from 3-in-1 cable on gain/pit on G31
Anybody has experienced this before? Tks much for your help.
David
Was trying to setup the Robird G31 using the Walkera Rx1002 receiver. In the Robird software, it can only detect the throttle. No elevator, no aileron, no rudder. I connected the Robird to the receiver as follow:
ELEV : connect the elevator on G31
AILE : connected the aileron on G31
THRO : connected the ESC
RUDD : connected to RUDD on G31
GEAR: nothing connected here
AUX 1 : connected red plug from 3-in-1 on gain/pit on G31
AUX 2 : connected white plug from 3-in-1 cable on gain/pit on G31
Anybody has experienced this before? Tks much for your help.
David
Comment