If this is your first visit, be sure to
check out the Rules and Help. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
this may be out of topic but sure is related to conversion project.
Super work done by others ....... transform a toy tug into a almost full scale tug ..... so nice The pic of before and after
time to plan for mod project after the bismarck
nice... Are you gonna display your ship during the SAF YC carnival?
Hangar:
IJN Yamato (RC, EP)
fitted with workable searchlight
1/350 Tamiya,
converted from static
DKM Bismarck (Static)
USS Missouri (Static)
--------------------
Shipyard:
Schnellboot S-100 Klasse (RC, EP)
USS New Jersey (RC, EP)
-------------------
Home Waters: Tanah Merah (my condo)
Boating hours: 9.30pm+ (night ops)
-------------------
finally done with the seal for the WTC ...... I used some rubber seal material so when the deck is mounted onto the hull it will "compress" it and form the necessary seal again water...... hope it work
the deck is hold down to the hull with 11 screw ..... and alot of hot glue on the WTC
where else ......Artsfriend lor ...... but it come in 1 inch thick and you have to "cut" it down to the thickness you need ....... I cut it down to 5 to 6 mm with hot wire cutter
initial was plan to use it for plane but now become boat
I have been doing plastic models for years and it has been a dream of mine to make a rc conversion, but i dont know what parts i need or how to convert, anyone can teach?
You need a radio with 2 or 3 channel. More if you want to control other moveable part of the boat. I assume you are talking about 1/350 or 1/250 scale battle ship. A small prop.... 20mm, prop shaft and small motor, esc and small lipo batt.
Comment