Tail Shaft tool for Hornet

[MicroHeli-Nut]

Took me 15 minutes to saw and file. It's for taking out and inserting the metal tail shaft.

Can someone give me suggestions please? It works, but the boringmotion is not that straight as it is a small hobby clamp, plus the end of it is round with small surface area......

[dabiddo]

errr..... how to you use this little thing?????

[MicroHeli-Nut]

The notch fits over the shaft, then screw in to press in the shaft into the bearings. To remove, get a 2mm steel rod and do the same for the opposite side.

To my suprise, not much force was needed..... and it was easier than i tot.