T E A M
Any explanation ? I'm using etec 1700. I manually set it to 9v cut off. Will upgrading the software for the esc help ? If so, how to upgrade ? Who has the 'usb' link ?
-
-
Some forum members got the USB stuff. I think is time to check your batt balance.Originally posted by genexis
Cheers -
I think the CC25 actually cut off at the correct 9V. Under high current draw, the voltage will drop more than at low current.
I had the same case on my Lipos, the CC25 cut off and when I connect my Lipo to the Triton charger to discharge, it showed 10V, but within 2 mins of discharging, the voltage dropped to 9V.
So I think the CC25 cut off at the correct voltage.Futaba FF9CHP
T-Rex 450X V2 with Alu swashplate
4xHS56, Hitec electron 6, PHX-25, Gy401, Mega 16/15/3 motor.
T-Rex 450X V2 with Alu swashplate
4xHS56, Schulze Alpha 840ww, PHX-35, GY401, Lehner 1020/17 motor.Comment
-
Yep, this is somehow already settled. I connected a volt meter across and powered up, it dropped < 9V
Comment
-
sounds like one of your cells is busted ..check the voltage across each cell they should be the sameComment
-
I threw both my cells away already Awaiting for new ones to arrive. May take a while.... sigh ... i need them fast :PP
Comment
Comment