T E A M
Those with E-Sky 4 in 1 can connect external ESC for Brushless setup.
Easy modification.
Easy modification.
-
2.4G -
Hi
My owning a Honeybee too.. If go brushless, just connect the ESC to the motor out will do?__________________
Tx : Eclipse 7 Mode 1
Plank
P-51 Mustang 0.25 size, gift from Invisible Angel.
Akro 804M(GP to EP), Built by Mr Bong in 1985, a gift from Daniel Soon - KIA
Phoenix Domino Trainer (EP) no1, eated by tree
Phoenix Domino Trainer (EP) no2, maiden on 17 Oct 09 at Anchorvale
Clouds Fly(EP), convert to night flyer?
Heli
Honey Bee Fp flight time - 110 hrs : Pass on to Invisible Angel for him to practice
Hirobo GPH346 flight time - alot of CP 15% liao
-
no i think you will need a y yoke so that the tail mixer is still getting a signal from the throttle so ti has the rigth mixing rate.
cheers dougComment
-
E-Sky 4 in 1
To go brushless, you will need an external brushless ESC.
You have to solder the BL ESC signal lead (yellow) on the rx thro ch and signal ground (brown). Do not connect the red wire.
Thanks2.4GComment
-
Wow very deep
I think i go brushless in my next heli... thinking of getting T-rex one day__________________
Tx : Eclipse 7 Mode 1
Plank
P-51 Mustang 0.25 size, gift from Invisible Angel.
Akro 804M(GP to EP), Built by Mr Bong in 1985, a gift from Daniel Soon - KIA
Phoenix Domino Trainer (EP) no1, eated by tree
Phoenix Domino Trainer (EP) no2, maiden on 17 Oct 09 at Anchorvale
Clouds Fly(EP), convert to night flyer?
Heli
Honey Bee Fp flight time - 110 hrs : Pass on to Invisible Angel for him to practice
Hirobo GPH346 flight time - alot of CP 15% liao
Comment
Comment